RESUMEN
Low-carbon cementitious materials based on blast furnace slag (BFS) and municipal solid waste incineration (MSWI) fly ash play a pivotal role in the construction industry by substituting cement clinker. This innovation significantly reduces CO2 emissions and enables the extensive utilization of both industrial solid waste and hazardous urban waste on a large scale. However, the application of MSWI fly ash as a precursor for alkali-activated cementitious materials presents a significant leaching risk of heavy metal during the extended reaction process, posing a critical barrier to the efficient and widespread utilization of these solid waste. Three static leaching methods [horizontal vibration (HV), sulphuric acid & nitric acid (SN), and acetic acid buffer solution (AAB)], along with acid neutralization capacity (ANC) leaching tests, were applied in BFS-fly ash-based cementitious materials (BFCM) to assess the leaching behavior of high-risk elements-Cr, Sb, and Pb-within MSWI fly ash. The A4 matrix (BFS: MSWI fly ash:FGDG = 70:20:10) exhibits a compressive strength of 72.51 MPa at 180 day, with the leaching concentrations of target elements remaining below the standard limit under chemical attack (H+ and OH-). The critical pH determined is 9.2 from the ANC leaching test results. Visual MINTEQ simulation illustrates the occurrence states of Cr, Sb, and Pb as (CrO4)2-, [Sb(OH)6]-, and Pb(OH)3- within the BFCM system, respectively. The "double salt effect", intended to enhance the dissociation degree of BFS, acts as the driving force behind the long-term hydration reaction. It also serves as an assurance in controlling the long-term leaching risk of object elements. The dissociation degree of BFS within A4 matrix increased by 38.71 %, with the relative content of the typical low-solubility double salt "Ettringite" reaching 29 % at 180 d. This study provides novel theoretical and data-driven evidence to investigate the leaching behavior associated with MSWI fly ash and the accomplishment of replacing cement clinker with low-carbon BFCM.
RESUMEN
The disposal of nonferrous metal tailings poses a global economic and environmental problem. After employing a clinker-free steel slag-based binder (SSB) for the solidification/stabilization (S/S) of arsenic-containing tailings (AT), the effectiveness, leaching risk, and leaching mechanism of the SSB S/S treated AT (SST) were investigated via the Chinese leaching tests HJ/T299-2007 and HJ557-2010 and the leaching tests series of the multi-process Leaching Environmental Assessment Framework (LEAF). The test results were compared with those of ordinary Portland cement S/S treated AT (PST) and showed that the arsenic (As) curing rates for SST and PST samples were in the range of 96.80-98.89% and 99.52-99.2%, respectively, whereby the leached-As concentration was strongly dependent on the pH of the leachate. The LEAF test results showed that the liquid-solid partitioning limit of As leaching from AT, SST, and PST was controlled by solubility, and the highest concentrations of leached As were 7.56, 0.34, and 0.33 mg/L, respectively. The As leaching mechanism of monolithic SST was controlled by diffusion, and the mean observed diffusion coefficient of 9.35 × 10-15 cm2/s was higher than that of PST (1.55 × 10-16 cm2/s). The findings of this study could facilitate the utilization of SSB in S/S processes, replacing cement to reduce CO2 emissions.
